How to Measure Your Ring Size at Home — India Ring Size Chart (2026)

Buying a ring online comes down to one nervous question: will it fit? The good news is you can find your ring size accurately at home in a couple of minutes, with nothing more than a strip of paper and a ruler. This guide gives you three simple methods, an India ring size chart, and the small tricks jewellers use to get it right the first time — so your ring arrives ready to wear.

Method 1 — The paper or string strip (easiest)

This needs only a strip of paper, thread, or a thin ribbon, plus a ruler:

1. Cut a strip about 10 cm long and 5 mm wide.
2. Wrap it around the base of the finger you'll wear the ring on — snug, but not tight enough to dent the skin.
3. Mark the point where the strip overlaps with a pen.
4. Lay it flat against a ruler and measure the length up to your mark, in millimetres. That's your finger circumference.
5. Find that measurement on the chart below to read off your size.

If your reading falls between two sizes, go with the larger one — a ring should slide over the knuckle without a fight.

Method 2 — Measure a ring that already fits

If she (or you) already own a ring that fits the intended finger well, this is the most reliable method of all. Place the ring on a ruler and measure the inside diameter — straight across the inner edge — in millimetres. Then match that diameter to the chart. This is also the sneakiest way to size a surprise gift: borrow a ring she wears on the right finger for a day and measure it.

Method 3 — A printed ring sizer

Many people find a printable sizer easiest. You print a size guide to scale, then either slide an existing ring over the printed circles until one matches, or cut out the measuring strip and wrap it around your finger. Just make sure your printer is set to 100% / "actual size," not "fit to page," or the scale will be off. Our Size Guide page has the exact chart we use to make your ring.

India ring size chart

Indian ring sizes are numbered, and each number maps to a finger circumference and inside diameter. Use your measurement from the methods above to find your size:

These figures are a general guide and can vary slightly between jewellers. For the exact sizing we use on your piece, always check our official Size Guide before ordering.

Tips to get the truest size

• Measure at the end of the day. Fingers are smallest in the cool morning and swell slightly by evening — size to the larger, everyday reality.
• Warm hands, not cold. Cold shrinks your fingers and gives a size that'll feel loose later. Measure when your hands are at normal temperature.
• Mind the knuckle. If your knuckle is much wider than the base of your finger, size so the ring passes the knuckle comfortably, then sits without spinning.
• Wide bands run tight. A broad band feels snugger than a thin one, so for chunky styles consider going up half a size.
• Measure more than once. Take the reading two or three times and trust the average — it's easy to pull the strip too tight on the first go.

How to find her ring size for a surprise

Planning a surprise? The simplest trick is to quietly borrow a ring she already wears on the correct finger and measure its inside diameter against the chart. You can also trace the inside circle of one of her rings on paper, or ask a close friend to help. We've written a full guide on finding her ring size without her knowing if you want more sneaky-but-effective ideas.

What if you're between sizes — or it doesn't fit?

If you land between two sizes, order the larger one; a jeweller can always snug a ring down more easily than stretch it up, and a slightly loose ring is more comfortable than a tight one. And if the fit isn't right when it arrives, it's not the end of the story — every Ornate piece is covered by our Lifetime Exchange, so we'll help you get to the perfect fit.

Frequently asked questions

How do I measure my ring size at home?

Wrap a thin strip of paper or thread around the base of your finger, mark where it overlaps, and measure that length in millimetres to get the circumference. Match it to an India ring size chart. Alternatively, measure the inside diameter of a ring that already fits.

What is the most accurate way to find ring size?

Measuring the inside diameter of a ring that already fits the intended finger is the most reliable method, because it removes any guesswork from wrapping a strip. Match that diameter to the size chart.

Should I size up or down if I'm between sizes?

Size up. A ring needs to pass the knuckle comfortably, and a jeweller can resize a slightly large ring down more easily than stretching a tight one. A marginally loose fit is also more comfortable for daily wear.

Does the time of day affect ring size?

Yes. Fingers are smallest in the morning and swell slightly through the day and in warm weather. Measure at the end of the day, with warm hands, for a size that fits in real life.

Can I resize or exchange a ring if it doesn't fit?

Yes. Ornate pieces are covered by a Lifetime Exchange, so if the fit isn't right we'll help you sort it out.

Found your size? Explore everyday and statement rings in BIS-hallmarked 925 silver. Shop silver rings →  ·  Read the jewellery care guide